SPIT 321 Manual Original página 9

line can lead to explosion. Penetrating a water line
causes property damage or may cause an electric
shock.
X When working with the machine, always hold it
firmly with both hands and provide for a secure
stance. The power tool is guided more secure with
both hands.
X Secure the workpiece. A workpiece clamped with
clamping devices or in a vice is held more secure
than by hand.
X For drilling without impact in wood, metal, ceramic
and plastic as well as for screwdriving, tools without
SDS-plus are used (e.g., drills with cylindrical shank).
For these tools, a keyless chuck or a key type drill
chuck are required.
X SPIT 323, SPIT 330 RAMSET DD 529. Only use
quick change chucks with 3 identification grooves
(standard delivery scope) or 2 identification grooves
(accessory/spare part) – see figure 1, page 69.
– The quick change chuck is automatically loc-
ked. Check the locking effect by pulling the quick
change chuck.
X Inserting SDS-plus Drilling Tools: Check the lat-
ching by pulling the tool.
X Replace a damaged dust protection cap imme-
diately. The dust protection cap largely prevents the
penetration of drilling dust into the tool holder during
Symbols
The following symbols are important for reading and understanding the operating instructions. Please take note
of the symbols and their meaning. The correct interpretation of the symbols will help you to use the machine in a
better and safer manner.
Symbol
321 / 323 / 330 / DD 522 / DD 529
Rotary Hammer
Grey-marked area: Handle
(insulated gripping surface)
Read all safety warnings and all
instructions
Wear protective gloves
Tool holder
Movement direction
Meaning
operation. When inserting the tool, pay attention that
the dust protection cap is not damaged.
X Dusts from materials such as lead-contai-
ning coatings, some wood types, minerals
and metal can be harmful to one's health and
cause allergic reactions, lead to respiratory
infections and/or cancer. Materials containing
asbestos may only be worked by specialists.
- Provide for good ventilation of the working place.
- It is recommended to wear a P2 filter-class respirator.
Observe the relevant regulations in your country for
the materials to be worked.
X Prevent dust accumulation at the workplace.
Dusts can easily ignite.
X If the application tool should become blocked,
switch the machine off. Loosen the applica-
tion tool.
X Before switching on the power tool, make sure
that the application tool moves freely. When
switching on with a blocked drilling tool, high torque
reaction can occur.
X Always wait until the machine has come to a
complete stop before placing it down. The tool
insert can jam and lead to loss of control over the
power tool.
Symbol
Before any work on the machine
itself, pull the mains plug from the
socket outlet
Wear ear protection
Wear safety glasses/goggles
Right/left rotation
Reaction direction
English | 9
Meaning