Functions Of The Remote Operation; Query Of The Alarm Duration; Query Of The Battery Status; Battery Change Mode (Deactivation Of The Sabotage Protection) - Schwaiger SECURE-4-YOU HG2000 Instrucciones

USER MANUAL HG2000 532
6.2. Functions of the remote control
Operating buttons of the remote control
ARM
HOME
By pressing the
By pressing the
PANIC
By simultaneously pressing the
ARM/DISARM
These buttons can be used to activate the system (ARM) or to deactivate it (DISARM).
Battery status
By simultaneously pressing the
be activated or deactivated.

6.2.1. Query of the alarm duration

To do this, press
of the sirens.
LED Code (flashing)
Alarm duration

6.2.2. Query of the battery status

To do this, press
the sirens.
An LED that is continually illuminated red shows a good to full status of the batteries.
If the LED only continues to flash, then it is recommended to replace the batteries.

6.2.3. Battery change mode (deactivation of the sabotage protection)

This mode is important for being able to complete a battery change, without setting off the alarm of the outdoor
siren. To do this, press
The outdoor siren additionally displays the deactivated state of the sabotage protection through the lighting up of
all 6 blue LEDs. This mode switches itself off again automatically after a maximum of 1 hour. Therefore the alarm
system is active, even when activation was forgotten.
Completing a battery change:
1. Deactivate the manipulation protection by pressing the buttons simultaneously
2. All blue LEDs now light up.
3. Remove the screws of the front cover (on the lower tip of the siren) using a Phillips screwdriver and then
remove the front cover.
4. Deactivate the siren by moving the switch to the
5. Now you can replace the batteries and then reactivate and mount the siren
6. Deactivate the battery change mode using the button
16
ALERT
ENTER CHANGE
BATTERY MODE
DISARM
button the battery status of the outdoor siren can be queried.
button, the alarm duration can be queried.
on the remote control. Now you can read the alarm duration from the flashing of the LEDs
Once Twice
1 minute 3 minutes
on the remote control. Now you can read the battery status from the flashing of the LEDs of
+ at the same time on the remote control.
and buttons, an alarm is immediately set off.
ARM DISARM
and the buttons, the sabotage protection can
Three times
5 minutes
OFF position.
.
+ .
(ON position).