HAMPTON BAY 56268 Guía De Uso Y Cuidado página 7

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Assembly - Standard Ceiling Mount
1
Preparing for mounting
Remove the canopy ring (L) from the canopy (C) by turning
the ring to the right until it unlocks.
Remove the mounting bracket (A) from the canopy (C) by
loosening the four screws (SS) on the top of the canopy (C).
Remove the two non-slotted screws, and loosen the slotted
screws. This will enable you to remove the mounting bracket
(A).
3
Assembling the fan
WARNING: Failure to properly install the locking pin (DD)
could result in the fan becoming loose and possibly
falling.
WARNING: Failure to properly install set screw (GG) could
result in fan loosening and possibly falling.
Loosen, but do not remove, the setscrew (GG) on the collar (M) on
top of the fan-motor assembly (D).
Align the holes at the bottom of the ball/downrod assembly (B) with
the holes in the collar (M) on top of the fan-motor assembly (D).
Carefully insert the hanger pin (CC) through the holes in the collar
(M) and ball/downrod assembly (B). Be careful not to jam the hanger
pin (CC) against the wiring inside the ball/downrod assembly (B).
Insert the locking pin (DD) through the hole near the end of the
hanger pin (CC) until it snaps into its locked position.
Re-tighten the setscrew (GG) on the collar (M) on top of the fan-
motor assembly (D).
2
Routing the wires
Route the wires exiting the top of the fan motor (D) into
the decorative motor collar cover (F) and through the
canopy ring (L).
Make sure the slot openings are on top and route the
wires through the canopy (C) and then through the ball/
downrod assembly (B).
A
SS
C
L
CC
M
7
Please contact 1-877-527-0313 for further assistance.
C
L
B
F
D
B
F
DD
GG
D
HAMPTONBAY.COM

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

5626956270672-934672-000672-066

Tabla de contenido