Cleaning And Maintenance; Control Panel And Body Of The Appliance; Cleaning The Ironing Dummy - Siemens TJ10 500 Manual Del Usuario

Control panel and body of the
appliance
When necessary:
❏ Use soapy water or a mild cleaning product.
Dry with a soft cloth.
Warning!
Do not use solvents or abrasive
detergents.

Cleaning the ironing dummy

When necessary or when the dummy is
clearly dirty, the ironing dummy can be
laundered together with your shirts. Use a mild
detergent and a programme for delicate
garments at 40 C.
0
❏ Do not use fabric softeners or starch.
❏ The ironing dummy can only be dried
naturally (do not use a tumble drier).
Warning!
The ironing dummy cannot be ironed. Fit it
straight back onto the shirt ironer when
dry.
The ironing dummy assembly consists of the
cover material (outer ironing dummy) and the
airbags. The airbags are located inside the
outer ironing dummy and are attached to the
frame independently.
Warning!
Allow the shirt press to cool down before
removing the ironing dummy.
Removing the ironing dummy
❏ Close the flaps on the button band adjuster.
❏ Remove the short sleeve button arm straps
if necessary.
❏ Remove the cuff adjusters by realising the
snap fastener.
❏ Completely loosen the adjustment cords on
the bottom right-hand side of the ironing
dummy.
❏ Fully open the collar adjuster.
❏ Open the collar support.
❏ Lightly press the clip on the back of the
head upwards. Fig. 16.

Cleaning and maintenance

30
❏ Remove the upper head section from back
to front. 11, Fig. 2.
❏ Unlock the button band adjuster: Pull the
unlocking ring upwards. Fig. 17.
Warning!
The button band adjuster tilts forwards.
Support it with one hand.
❏ Open the two adjustment cords in the head
area, which is now accessible. Extract them
from their guides. Fig. 18.
❏ Open the cord fixture on the rear edge.
Extract them from their guide. Fig. 19.
On the front, the cord is fitted behind the
button band and secured with the guides
fitted for this purpose.
❏ Turn the collar adjuster knob to its vertical
position.
❏ Grip the ironing dummy from the bottom
and carefully pull upwards.
❏ Pull the ironing dummy from front to back
over the collar adjuster. Fig. 20.
❏ You hold now the ironing dummy cover.
Open the snap fasteners which join the
sleeves of the ironing dummy to the
airbags.
The airbags are still on the frame and need to
be removed:
❏ Open the six snap fasteners on the
shoulders, the snap fasteners in cross
formation on the front and the snap
fasteners around the left-hand tube on the
front at the bottom.
❏ Release the adjustment cord fixture at the
bottom of the airbags. Extract them from
the guide groove.
The ironing dummy and the airbags can now
be washed.
Fitting the ironing dummy
Make sure that nothing enters the air ducts
which are now accesible.
It is essential that the ironing dummy be
fitted correctly in order to obtain optimum
ironing results.