Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Q1:
How do I configure TCP/IP settings on my computer?
1. Go into the Control Panel, double-click the Network
Connections icon, and then right-click the Local Area
Connection icon and then click Properties.
Q2:
: I typed http://192.168.223.100 in my Internet Browser's Address Bar, but an error message
says "The page cannot be displayed." How can I get into the TEG-S2620i's web configuration
page?
A2:
First, check your hardware settings again by following the instructions in section 2.
Second, make sure the POWER and LINK/ACT lights are lit. Third, make sure the TCP/IP
settings are configured properly (see Q1). Fourth, since the Switch's default IP address is
192.168.223.100, make sure that no other network devices are assigned an IP address of
192.168.223.100.
Q3:
If my network's IP is different than the Switch's range, what should I do?
A3:
You should still configure the Switch first. After all the settings are applied, go to the
Switch's configuration page, click on Administrator, click IP & Management Mode and change
the IP address of the Switch to match your network's IP.
Q4:
What are the default port settings for configuring the Switch through the console port
using HyperTerminal?
A3:
Bits per Second: 115200; Data bits: 8; Parity: None; Stop bits: 1; Flow control: None.
If you still encounter problems or have any questions regarding the TEG-S2620i, please contact
TRENDnet's Technical Support Department.
2. Click Internet Protocol (TCP/IP) and then click
Properties. Then click on Use the following IP
address, and make sure you assign your network
adapter an IP address in the subnet of 192.168.223.x.
6
Publicidad
