Keystone DD7L Junior Manual De Instrucciones página 10

Water not draining down Hose is fitted for continuous drainage but the water still
the hose goes into the tank.
Dehumidifier leaks water Usually means that the dehumidifier is not on a level
onto the floor surface or that the filter has not been cleaned often
enough and dirt has fallen into the dehumidifier.
Machine not switching Temperature and relative humidity sensor that reads the
off and on in the usual room reading is unable to read the correct readings.
30 minute pattern
Unit only works in If the humidity sensor is faulty then the dehumidifier will
Laundry mode and only run in Laundry mode.
Laundry light stays on or
flashes.
Medium fan speed light None of the buttons work.
flashes
If one of the following events happens then the control panel will lock up and the dehumidifier will run in a higher fan
speed.

Temperature below 50°F / Temperature above 104°F

Relative humidity below 40%rh

Machine has been working hard and needs to cool down internally
If you find that this happens and none of the buttons on the control respond, then do not worry, this is normal and
the dehumidifier is still drying the air as per the setting you left it in. The control panel will start to work again when the
conditions allow.
To avoid issues please clean the filter at least every couple of weeks.
This marking indicates that this product should not be disposed with other household wastes throughout the EU. To
prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to
promote the sustainable reuse of material resources. To return your used device, please use the return and
collection systems or contact the retailer where the product was purchased. They can take this product for
environmental safe recycling.
Negative air pressure in the room is pulling the water back
into the dehumidifier overflow. Insert a 4mm hole into the
top of the tube 30mm down from the spout. This will
introduce air into the tube and balance out the air
pressure.
You can also check that the water bucket is not cracked
by filling it with water and placing it on kitchen paper on
the kitchen side.
Clean the filter and blow the air sensor with a hair dryer on
fast setting to clear the sensor of dirt. Unplug the
dehumidifier for 10 minutes to reset it's circuits and then
turn back on.
Try clearing the sensor as per above line, if that fails then
call Keystone for a repair.
This is normal and the unit is functioning ok. The unit will
return to normal operation when conditions allow. More
details below.
10 [EN]