Mounting The Hood; Electrical Connection - arietta ALS436SS Guía De Instrucciones Para Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Mounting the hood

1.
Install transition on top of hood (if removed for shipping) with
2 - 3.5 x 9.5 mm sheet metal screws.
A. Vent transition
B. 3.5 x 9.5 mm screw
WARNING
2 people are required to lift and position the hood
onto the mounting screws.
Place the template on the wall along the horizontal line, make sure
the template is leveled and centered with the centerline.
Mark "upper" screw holes locations in the wall
IMPORTANT: Check to be sure that hole locations are leveled and
correctly centered bye the vertical centerline.
Drive "upper" wood screws by hand. Leave ¼" of distance between
the screw head and the wall.
¼˝
(6.4mm)
Remove the grease filter and mount the hood onto the "upper screws".
B
A
■ Mark "lower" wood screw holes locations in wall using a pencil.
Remove the hood.
Drive the "lower" wood screws, by hand. Remove screws.
Mount the hood onto the "upper" wood screws, by hand.
Drive and tighten the "lower" wood screws, by hand.
A
B
A. 5 x 45 mm screw
B. Mounting slots

Electrical Connection

WARNING
Electrical Shock Hazard
Warning: Turn off the power circuit at the service
panel before wiring this unit.
120 VAC, 15 or 20 Amp circuit required.
ELECTRICAL GROUNDING INSTRUCTIONS
THIS APPLIANCE IS FITTED
BOX WITH 3 WIRES, ONE OF WHICH (GREEN/YELLOW) SERVES
TO GROUND THE APPLIANCE. TO PROTECT YOU AGAINST
ELECTRIC SHOCK, THE GREEN AND YELLOW WIRE MUST BE
CONNECTED TO THE GROUNDING WIRE IN YOUR HOME ELEC-
TRICAL SYSTEM, AND IT MUST UNDER NO CIRCUMSTANCES BE
CUT OR REMOVED.
Failure to do so can result in death or electrical shock.
6
A
WITH AN ELECTRICAL JUNCTION

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido