Chapter 7 | Additional Options / Numerical Codes - DRAMINSKI HMM Manual De Uso

Setting up numerical codes.
• the device must be switched on.
• to enter the mode of writing numerical codes press
four buttons at a time MAX + MIN + T/M + ON/
OFF.
• when you see "CAL" release the buttons.
• on display you will see the flashing colon ( : ) on the
left and value "00".
• with the help of MAX (up arrow) and MIN (down
arrow) set up a given numerical code you want to
activate
•confirm the code with T/M buttons.
• then switch off the device holding ON/OFF button
till "OFF" appears on the display (about 2 seconds).
24

CHAPTER 7 | ADDITIONAL OPTIONS / NUMERICAL CODES

1. Switching on temperature compensation
(enabled by default).
- set code "101" and confirm it with T/M button.
- you will see the message "ko;'".
- then switch off the device.
2. Switching off temperature compensation.
- set code "100" and confirm it with T/M button.
- you will see the message "kOF".
- then switch off the device.
3. Changing temperature into
(enabled by default).
- set code "01" and confirm it with T/M button.
- you will see the message "°C".
- then switch off the device.
4. Changing temperature into
- set code "02" and confirm it with T/M button.
- you will see the message "°F".
- then switch off the device.
C scale
o
F scale.
o