Midwest Solutions SL54DD Manual Del Usuario página 2

AssEMBly INstrUCtIoNs
1. remove the contents of the carton. sort and
identify all the pieces described in the Parts
Identification. remove the Corner rods from the
loops of the Door Panel and Back Panel.
2. locate the Bottom Panel (A) and place it flat on
the floor with the hooks extending upward as
shown. locate the Pan stop attached to one end.
this is the front of the crate and will serve as your
point of reference.
3. locate the side Panel with Door (B) and side
Panel (C). lay them flat on the floor, one on each
lengthwise side of the Bottom Panel. the side
Panel with the Door should be on the right side of
the Pan stop. the door's slide-bolt latches will be
facing the floor at this point. the loops on the
short ends of each side Panel should face
upward.
lift the long edge of each side Panel that is
closest to the Bottom Panel and place the long
edge over the hooks of the Bottom Panel. the
long hooks of the Bottom Panel that extend
upward should rest between the second and
third long horizontal wire of each side panel.
4. Using both hands (or with the assistance of a
friend), pull the two side Panels outward (away
from the Bottom Panel) and upward to form a
"U" shape.
Make sure the second horizontal wire from the
bottom of each side Panel slides up to connect
inside the upright hooks of the Bottom Panel.
Pan stop
second Wire
Bottom Wire
Panel fit around/over the second
horizontal wire of each side panel.
the long hooks of the Bottom
2