Bühler technologies BCM-WS, BCM-WD Guía Rápida página 12

BCM
Possible errors
Problem / Possible cause
Malfunction
Switching out- • Switching out-
put not trig- put configured
gering when incorrectly
exceeding lim-
its
• Switching out-
put defect
Switching out- • Switching out-
put constantly put configured
switching incorrectly
• Switching out-
put defect
The analogue • Wrong signal
doesn't re- type set
ceive the full/
correct output
current
• Load too high
(current output)
Analogue out- • Analogue output
put doesn't configured in-
change the correctly
output signal
when the in-
put signal
changes
12 Bühler Technologies GmbH
Action
• In submenu Coux:
"Test Switching
Output" to ensure
normal mode
• In submenu Coux:
"Test Switching
Output" to test the
desired switching
output
• In submenu Coux:
"Test Switching
Output" to ensure
normal mode
• In submenu Coux:
"Test Switching
Output" to test the
desired switching
output
• In submenu Aoux:
Check and if neces-
sary set the correct
signal type (cur-
rent/voltage out-
put)
• Reduce load to per-
missible value
• In submenu CAnx:
„Test Analogue Out-
put" to ensure nor-
mal mode
BX150101 ◦ 03/2018