GreenWorks GPW 1702 Manual Del Operador página 19

STARTING AND STOPPING THE PRESSURE WASHER
CAUTION :
Do not run the pump without the water supply connected and turned on.
Connect the garden hose.
Turn the garden hose on then squeeze the high pressure trigger to relieve air pressure. Once a steady
stream of water appears, release the trigger.
$IWHU HQVXULQJ WKH 2Q2II VZLWFK LV LQ WKH 2)) SRVLWLRQ FRQQHFW WKH SUHVVXUH ZDVKHU WR WKH SRZHU
supply.
Plug the pressure washer into the outlet and ensure the light on the GFCI is on, the unit is ready for
operation.
6ZLWFK WKH SUHVVXUH ZDVKHU WR WKH ,21 SRVLWLRQ WR VWDUW WKH PRWRU
7R VWRS WKH PRWRU UHOHDVH WKH WULJJHU DQG WXUQ WKH VZLWFK WR WKH 2)) SRVLWLRQ
W A R N I N G
Hold the handle and wand securely with both hands. Expect the trigger handle to move when the trigger
LV SXOOHG GXH WR UHDFWLRQ IRUFHV )DLOXUH WR GR VR FRXOG FDXVH ORVV RI FRQWURO DQG LQMXU\ WR \RXUVHOI DQG
others.
NOTE: AUTO ON/OFF SWITCH: This Pressure washer is equipped with an Auto Start/Stop
feature.
To operate: Turn the power switch to the On (I) position. Pump will pressurize and shut down
immediately. Once the trigger of the gun is depressed the unit will turn on. Unit will shut off and
be in standby mode when trigger is released.
SOAP APPLICATION
Soap is applied under low pressure high volume for optimum performance.
Soap can not be applied under high pressure with this machine
6RDS  'HWHUJHQW FDQ RQO\ EH DSSOLHG ZLWK WKLV PDFKLQH ZKHQ WKH GHWHUJHQW WDQN LV LQVWDOOHG
OPERATION
EN - 16