Stopping The Generator - Firman SPS1000i El Manual Del Propietario

12V DC Outlet – Battery Charging
1. Before connecting the battery charging cable to a battery that is installed in a vehicle,
disconnect the vehicle battery ground cable from the negative (–) battery terminal.
2. Plug the battery charging cable into the 12V DC receptacle of the generator.
3. Connect the red (+) battery charger lead to the red(+) battery terminal.
4. Connect the black (–) battery charger lead to the black (–) battery terminal.
5. Start the generator.
[CAUTION]
When using the 12V DC outlet, turn the Economy mode switch to the "OFF" position. Be
sure all electric devices including the lines and plug connections are in good condition
before connection to the generator.

STOPPING THE GENERATOR

1. Turn off and unplug all electrical loads. Never start or stop the generator with electrical
devices plugged in or turned on.
2. Let the generator run at no-load for several minutes to stabilize internal temperatures
of the engine and generator.
3. Turn the Fuel Valve to the "OFF" position.
4. Let the engine run until fuel starvation has stopped the engine. This usually takes a few
minutes.
5. Turn the engine switch to the "Off" position.
6. Allow the generator to cool down completely to room temperature.
7. Turn the fuel cap lever vent to the "Off" position after the generator has cooled down
completely.
Important: Always ensure that the Fuel Valve and the Engine Switch are in the "OFF"
position when the engine is not in use.
[CAUTION]
Always ensure that the Fuel Valve and the Engine Switch are in the "OFF" position when
the engine is not in use.
Page 15