Sunex Tools SX227B Instrucciones De Uso página 2

FAILURE TO OBSERVE THESE WARNINGS
THIS INSTRUCTION MANUAL CONTAINS
IMPORTANT SAFETY INFORMATION.
READ THIS INSTRUCTION MANUAL CAREFULLY
AND UNDERSTAND ALL INFORMATION BEFORE
OPERATING THIS TOOL.
• Always operate, inspect and maintain this tool in accor
dance with American National Standards Institute
Safety Code of Portable Air Tools (ANSI B186.1) and any
other applicable safety codes and regulations.
• For safety, top performance and maximum durability of
parts, operate this tool at 90 psig 6.2 bar max air pres
sure with 3/8" diameter air supply hose.
• Always wear impact-resistant eye and face protection
when operating or performing maintenance on this tool.
Always wear hearing protection when using
this tool.
• High sound
hearing loss.
recommended
regulation.
• Keep the tool in efficient operating condition.
• Operators
be physically able to handle the bulk, weight
and power of this tool.
• Air under pressure can cause severe injury. Never
direct air at yourself or others. Always turn off the air
supply, drain hose of air pressure and detach tool from
air supply before installing, removing or adjusting any
accessory on this tool, or before performing any main
tenance on this tool. Failure to do so could result in
injury. Whip hoses can cause serious injury. Always
check for damaged, frayed or loose hoses and fittings,
and replace immediately. Do not use quick detach cou
plings at tool. See instructions for correct set-up.
• Air powered tools can vibrate in use. Vibration, repet
tive motions or uncomfortable positions over extended
periods of time may be harmful to your hands and
arms. Discontinue use of tool if discomfort, tingling
feeling or pain occurs. Seek medical advice before
resuming use.
• Place the tool on the work before starting the tool. Do
not point or indulge in any horseplay with this tool.
• Slipping, tripping and/or falling while operating air tools
can be a major cause of serious injury or death. Be
aware of excess hose left on the walking or work sur
face.
• Keep body working stance balanced and firm. Do not
overreach when operating the tool.
• Anticipate and be alert for sudden changes in motion
during start up and operation of any power tool.
SX227B: Parts Breakdown & Operating Manual
COULD RESULT IN INJURY
levels can cause permanent
Use hearing protection
by your employer or
and maintenance personnel
• Do not carry tool by the hose. Protect the hose from
• Tool shaft may continue to rotate briefly after throttle is
• Keep away from rotating end of tool. Do not wear
• Do not lubricate tools with flammable or volatile liquids
• Do not force tool beyond its rated capacity.
• Do not remove any labels. Replace any damaged
• Use accessories recommended by Sunex Tools.
as
OSHA
must
2
sharp objects and heat.
released. Avoid direct contact with accessories during
and after use. Gloves will reduce the risk of cuts or
burns.
jewelry or loose clothing. Secure long hair. Scalping can
occur if hair is not kept away from tool and accessories.
Choking can occur if neckwear is not kept away from
tool and accessories.
such as kerosene, diesel or jet fuel.
labels.
rev. 02/09/07