Air Supply - Sunex Tools SX227B Instrucciones De Uso

Operating Instructions • Warning Information • Parts Breakdown

Air Supply

Tools of this class operate on a wide range of air pressures. It is
recommended that air pressure of these tools measures 90 PSI at the
tool while running free. Higher pressure (over 90 psig; 6.2 bar) raises
performance beyond the rated capacity of the tool which will shorten the
tool's life because of faster wear and could cause injury.
Always use clean, dry air. Dust, corrosive fumes and/or water in the air
line will cause damage to the tool. Drain the air tank daily. Clean the
air inlet filter screen on at least a weekly schedule. The recommended
hookup procedure can be viewed in the above figure.
The air inlet used for connecting air supply, has standard 1/4" NPT. Line
pressure should be increased to compensate for unusually long air hoses
(over 25 feet). Minimum hose diameter should be 3/8" I.D. and fittings
should have the same inside dimensions and be tightly secured.
Lubrication
Lubricate the air motor daily with air tool oil. If no air line oiler is used,
run 1/2 oz. of oil through the tool. The oil can be squirted into the tool air
inlet or into the hose at the nearest connection to the air supply, then run
the tool. Overfilling will cause a reduction in the power of the tool.
Limited Warranty
SUNEX INTERNATIONAL, INC. WARRANTS TO ITS CUSTOMERS THAT THE COMPANY'S SUNEX TOOLS
PRODUCTS ARE FREE FROM DEFECTS IN WORKMANSHIP AND MATERIALS.
Sunex International, Inc. will repair or replace its Sunex Tools
workmanship or materials, based upon the terms and conditions of the following described warranty plans attributed to that specific product.
This product carries a ONE YEAR warranty. During this warranty period, Sunex Tools will repair or replace at our option any part or unit which
proves to be defective in material or workmanship.
Other important warranty information...
This warranty does not cover damage to equipment or tools arising from alteration, abuse, misuse, damage and does not cover any repairs or
replacement made by anyone other than Sunex Tools or its authorized warranty service centers. The foregoing obligation is Sunex Tools' sole
liability under this or any implied warranty and under no circumstances shall we be liable for any incidental or consequential damages.
Note: Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may
not apply to you. Please contact your local Sunex distributor for proper warranty handling procedures.
If you have any questions about warranty service, please write to Sunex Tools. This warranty gives you specific legal rights and you may also
have other rights which vary from state to state. Repair kits and replacement parts are available for many of Sunex Tools products regardless
of whether or not the product is still covered by a warranty plan.
Shipping Address: Sunex Tools • 315 Hawkins Rd. • Travelers Rest, SC 29690
Mailing Address: Sunex Tools • P.O. Box 4215 • Greenville, SC 29608
SX227B: Parts Breakdown & Operating Manual
Nipple
®
branded products which fail to give satisfactory service due to defective
4
Operation
The rotation of the shearing head can be changed by loosening
the allen head screw. Then turn cutter housing to desired posi-
tion and tighten allen head screw securely.
NEVER use this air shear on material with a gauge greater than
18 as this will result in breakage of the center blade.
Cutting with this tool will create sharp edges. Wear gloves to
protect hands.
Cutting edges and saw blades can become hot during use.
Do not touch.
Never force the tool to cut faster or through heavier gauge
material than rated capacity.
®
BRANDED
rev. 02/09/07