Features; Technical Data - Surtek PHIP12 Manual De Usuario Y Garantía

• Do not use the shop press unless it is properly
lubricated.
• Using a shop press that is not in good clean
working condition or properly lubricated may
cause serious injury.
• Inspect the work area before each use. Make
sure it is free and clear of any potential hazards.
DO NOT OPERATE OR REPAIR THIS EQUIPMENT
WITH OUR READING THIS MANUAL
To maintain the Shop Press and user safety, the
responsibility of the owner is to read and fol-
low these instructions. Inspect the service shop
press for proper operation and function. Keep
instructions readily available for equipment op-
erators. Make certain all equipment operators
are properly trained; understand how to safely
and correctly operate the unit. Allow unit oper-
ation only with all parts in place and operating
properly. Use only genuine replacement parts.
Service and maintain the unit only with autho-
rized or approved replacement parts negligence
will make the shop press unsafe for use and
void the warranty. Carefully inspect the unit on
a regular basis and perform all maintenance as
required. Store these instructions in the handle
of your shop press. Keep all decals on the unit
clean and visible.
SAFETY: always follow safety precautions when
installing and operating this shop press. Keep
all decals on the unit clean and visible. Before
proceeding that you fully understand and com-
prehend the full contents of this manual. Fail-
ure to operate this equipment as directed may
cause injury or death. The distributor is not re-
sponsible for any damages or injury caused by
improper use or neglect.

FEATURES

KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.

TECHNICAL DATA

PHIP12
CAPACITY
WORK RANGE
STROKE LENGTH
TABLE WIDTH
EXTERNAL WIDTH
PHIP20
CAPACITY
WORK RANGE
STROKE LENGTH
TABLE WIDTH
EXTERNAL WIDTH
12 t (24 000 lb)
(0 - 69,5) cm
14 cm (5-1/2")
40 cm
53 cm
20 t (40 000 lb)
(0 - 75) cm
18 cm (7")
50 cm
65 cm
E N G L I S H •
ASSEMBLY
Your press head frame, uprights and head tra-
verse ram plate has been pre-assembled at the
factory. You will be required to install the work-
table, ram, pumping unit and base angles.
Follow the simple instructions below for quick
assembly. Assembly may be made easier if the
frame is laid down flat with the front facing up-
ward.
1. Using (2) M8 x 20mm bolts, nuts and washers
install the union support to the bottom from of
the upright channels. (Pump hanger bracket on
the right hand side of the upright.) Angle is to
face outward see drawing below on right. Hand
tighten.
2. Install the union support to the inside of the
upright channels and base angles, using the 4 of
the M8 x 25mm bolts, nuts and washers provid-
ed. Place union support in-between the chan-
nels, and install the 2 base angles to the frame
through the union support and install nuts. Base
angles face outward (See drawing below). Hand
tighten.
Union support
3. Install the diagonal support straps. Using 4
M8 x 25mm bolts, nuts and washers. Install the
support straps to the inside of the base angles
then to the frame as shown. Finger tighten.
Support straps
U s er 's M an u al
Pump
hanger
bracket
Union
support
Base angle
9