Leckey Tour Mobility Base Instrucciones Para El Usuario página 27

The mobility base should only be used in
motor vehicles in a forward-facing seating
position.
The mobility base should only be used
with seating systems which have
passed crash testing, if being used for
transportation in a vehicle.
The mobility base should only be used for
transportation in a motor vehicle fitted
with anchor brackets, which comply with
National and International standards.
The person responsible for the
transportation of the individual in the
mobility base is also responsible for their
safety.
Alterations must not be made to the frame
or structural parts of the Leckey product.
If the mobility base is enabled with back
angle adjustment or tilt in space, the
user must be sitting fully upright during
transportation. If this is not possible
due to the user's condition a full-risk
assessment should be undertaken to
address the issue of the user's safety.
During transportation, you must ensure
that there are clear zones around the
mobility base and wheelchair user, as
shown in Figure 24: 650 mm at the front,
when the 3-point shoulder and pelvic belt
occupant restraint is used, and 400mm
at the rear. The required overall height
from the floor is between 1250 mm and
1550mm, depending on the height of the
user.
Fig 24