Leckey Tour Mobility Base Instrucciones Para El Usuario página 8

7.3 Fitting of accessories
Refer to Section 9
7.4 Mounting of the
seating system
To mount the Kit Seating System on the
mobility base release the safety locking pin at
the front of the seat by pulling the pin (A) out
and rotating it through 90 degrees. Carefully
tilt the seat and place it onto the chassis,
locating the channel (B) at the rear of the seat
over the tube at the back of the chassis (C).
Pull the handle (D) at the front of the seat
unit up and then pivot the seat down.
Once the seat is fully lowered, release the
handle and push it forward to ensure it has
fully engaged on the front tube. Rotate the
safety locking pin (A) so that it engages in the
front of the handle.
D
A
B
C