Troubleshooting - Oreck Task Vac CK93010 Manual De Usuario

Troubleshooting

WARNING
Problem
My TaskVac won't
™
turn on.
My TaskVac turns
™
off while in use.
My TaskVac does
™
not pick up dirt
My brushroll will not
turn.
Any other servicing should be done by an authorized service representative. If appliance is not
working as it should, has been dropped, damaged, left outdoors, or dropped into water, take it to a
service center prior to continuing use.
14
TO REDUCE THE RISK OF PERSONAL INJURY: REMOVE BATTERY PACK BEFORE CLEANING OR SERVICING.
BRUSHROLL MAY SUDDENLY RESTART IF BATTERY IS IN PLACE.
Possible Solution
1. Your battery may not be inserted properly. Make sure the battery is fully
seated in battery cavity.
2. Your battery may not be charged. Check the Charge Level Indicator and charge
the battery if it's low. The M-PWR
3. Your battery may be too hot. Remove battery and let cool for 30 minutes,
replace battery and retry or replace with second charged battery.
4. There may be internal component damage. Call for service: 1-800-989-3535.
1. Your battery may be out of charge. Remove and charge battery or replace with
second charged battery.
2. Your battery may be too hot. Remove battery and let cool for 30 minutes,
replace battery and retry or replace with second charged battery.
3. There may be internal component damage. Call for service: 1-800-989-3535.
1. The dirt cup may be full. Empty the dirt cup.
2. The filter may be dirty. Clean the filter.
3. The baffle tube may be dirty. Remove and clean.
4. The airpath may be clogged. Make sure the battery is removed and the
product is off. Remove nozzle by pressing the nozzle release button and
pulling the nozzle in a downward motion. Remove any debris clogged in the
nozzle airpath. Reattach nozzle to the product.
5. There may be internal component damage. Call for service: 1-800-989-3535.
1. The brushroll may have an obstruction. The airpath may be clogged. Make sure
the battery is removed and the product is off. Remove nozzle by pressing the
nozzle release button and pulling the nozzle in a downward motion. Remove
any debris clogged in the nozzle airpath. Reattach nozzle to the product.
2. The motor protection device may be tripped. Turn product to off position,
product will reset in approximately 30 minutes.
3. Your belt may be broken. Make sure the battery is removed and the product is off.
Remove nozzle cover replace with recommended belt and replace nozzle cover.
4. There may be internal component damage. Call for service: 1-800-989-3535.
20V battery does not come fully charged.
™