General Information And Safety Guidelines; Installation - Liberty Pumps CSP-237 Manual De Instalación

1. General Information and Safety Guidelines

Before installation, read the following instructions carefully.
performance. Closely following these instructions will eliminate potential operating problems, assuring years of trouble-free service.

Risk of electric shock. Always disconnect the pump from the power source before handling or making adjustments.

The electrical connections and wiring for a pump installation should only be made by qualified personnel.

This pump is supplied with a grounding conductor and grounding-type attachment plug. To reduce the risk of electric shock, be
certain that it is connected only to a properly grounded, grounding-type receptacle.

Do not bypass grounding wires or remove ground prong from attachment plugs.

Do not use an extension cord.

This pump requires a separate, properly fused and grounded branch circuit. Make sure the power source is properly sized for the
voltage and amperage requirements of the pump, as noted on the nameplate.

The electrical outlet shall be within the length limitations of the pump power cord, and at least 4 feet above floor level to minimize
possible hazards from flood conditions.

The installation must be in accordance with the National Electric Code and Plumbing Codes as well as all applicable local codes
and ordinances.

2. Installation

Fig. 1 – Typical Residential Installation
This is a recommended installation only.
Each Liberty pump is individually factory tested to insure proper
Figure 1
©Copyright 2011 Liberty Pumps Inc. All rights reserved -2-