What'S In The Box; Before You Start - Goalzero BOULDER Guia De Instalacion

WHAT'S IN THE BOX

Brackets x 4

BEFORE YOU START

The following tools are recommended for installation, but are in
no way a comprehensive list.
• Electric drill
• Silver marker or pencil
• 5/16" Drill Bit
• 10mm Wrench
• Cardboard or blanket
• Screwdriver for removing kickstand
Remove the kickstand from the Boulder Solar Panel before
installation with a Philips screwdriver. We also recommend
placing cardboard or a blanket between the Boulder and the
ground to protect the tempered glass.
1
Hex Cap Bolt x 4
Split Lock Washer x 4
Flat Washer x 4
Hexagonal Nut x 4
STEP 1: MEASURING AND DRILLING
1. Measure approximately 2 to 4" from the corner protectors to
the edge of the mounting bracket. The distance will depend on
individual installations.
2. Mark the position of the hole to be drilled, using the mounting
bracket as a guide.
3. Using the drill fitted with a 5/16" bit, make a hole for the bolt.
4. Repeat 1 through 3 for each mounting bracket.
1. Measure 2 to
4 inches from
corner protector to
edge of Mounting
Bracket
2. Drill hole for bolt
using Mounting
Bracket as guide
2