Placing Tool In Service - Facom NS.3500G Manual Del Usario

3. Remove accessory, connect the tool to an air source, then cover the exhaust end with a towel and run tool for 2 to 3
seconds.
To lubricate internal mechanism:
Locate the grease fi tting on the back of the tool (fi g. 5). Inject 4 grams of FACOM
approved impact grease into the fi tting every 3-5 months depending on use.
Use recommended grease gun nozzle tip (fi g. 6) on grease fi tting,
smaller or sharp nozzle will damage grease fi tting ball bearing.
WARNING: Keep out of the reach of children. If air tool oil is ingested, do not
induce vomiting, call a doctor immediately.
WARNING: Any excess oil in the tool is immediately expelled from the exhaust
port. Always direct exhaust port away from people or objects.
NOTE: Check the speed and make a simple check of the vibration level after each
service.
Storage:
The air tool must be lubricated before storing.
Follow the "Lubrication" instruction with exception of step 3.

PLACING TOOL IN SERVICE

Fig. 7
EMERGENCY
GATE VALVE
NU-NS.3500G-NS.3100G-NS.2500G_0118.indd 14
Always use an air line lubricator with this tool. Always use an air line lubricator with this tool. Always use an air line lubricator with this tool.
Do not over-oil and do not use heavy grade oil as stalling and low performance may result. Do not over-oil and do not use heavy grade oil as stalling and low performance may result. Do not over-oil and do not use heavy grade oil as stalling and low performance may result.
Fig. 5
Fig. 6
GREASE NOZZLE
TIP
An air fi lter unit should be placed between air compressor and
air lubricator to promote clean air supply to air hammer. Water,
dirt, and scale can damage air hammer.
14
3.0mm
08/01/2018 08:10:27