Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
16. Mount glass globe (C) to connect screw (GG) with one of the
decorative finials (G). Fig. 17
Turn on power at the service panel after finishing installation.
INSTALLATION IN NEW CONSTRUCTION
CAUTION: MAKE SURE POWER IS SWITCHED OFF AT
SERVICE PANEL BEFORE STARTING INSTALLATION.
1.
Insert the suspension brackets (F) into the fan body (A). If
joist spacing is between 21-1/4 in. and 23-1/2 in., connect
suspension bracket I (E) and suspension bracket II (F).
Fig. 18
2.
Position the fan body (A) so that the grille (B) will be flush with
the ceiling board when installed. Fig. 19
3.
Go to step 10 (page 8) to mount light socket assembly (D)
and grille (B). Mount the fan body (A) with the grille (B) and
light socket assembly (D) in place to the joist using the
suspension brackets and long wood screws (AA). Fig. 20
Go to step 5 (page 7). Follow steps to connect fan body (A),
wiring, light socket assembly (D) and glass globe (C).
10
Fig. 17
Fig. 18
Fig. 19
Grille
Fig. 20
www.homewerksww.com
Ceiling
board
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
