Publicidad
WATER PUMP INSTALLATION
1. Remove the water pump from the box.
2. Place the pump into the middle of the water tray along its side so that
the water outlet is positioned horizontally. Connect the water hose from
the blade guard to the pump and plug the power cord into the 3-prong
receptacle.
3. Fill the water tray so that the water intake is fully immersed.
WATER PUMP MAINTENANCE
When the machine has not been used for a long period of time, hard packed dirt
may begin to build up inside the pump and block the pump wheel. If the machine is
activated with the immersion pump blocked, the electric motor of the pump will be
damaged within a few minutes! Please follow the steps listed below to clean the
pump before operating the saw.
1.
Unscrew the pump filter.
2.
Remove the immersion pump from the water container.
3.
Clean the immersion pump.
4.
Loosen the fixing screws of the pump lid.
5.
Take the lid off the pump (be careful not to damage the gasket located inside
with a sharp object!)
6.
Clean the pump lid.
7.
Remove all dirt and incrustations from the pump wheel.
8.
Check whether the pump wheel can be easily turned.
9.
Then reassemble the immersion pump correctly and check whether it works
properly.
WATER PUMP SAFETY PRECAUTIONS
•
Never operate pump without water in the tray. F
that the water intake is fully immersed.
•
Be sure to connect the plug to a properly grounded receptacle to
reduce the risk of electric shock.
•
Disconnect the pump before attempting to handle the pump, to unclog
or service the pump in any way.
•
Be sure to support the pump during installation to prevent pump failure
or damage.
-15-
ill the water tray so
MANTENIMIENTO DE LA BOMBA DE AGUA
Cuando la maquina no ha sido usada por periodo largo de tiempo, quizas la
bomba y el rodete podrian estar atascados con residuos secos. Si la
maquina es encendida con la bomba de immersion atascada, el motor
electrico de la bomba podria danarse en pocos minutos! Por favor siga la
indicaciones paso a paso para limpiar la bomba antes de usar la sierra.
1.
Desatornille el filtro de la bomba.
2.
Quite la bomba de hundimiento de la bandeja del agua.
3.
Limpie la bomba de hundimiento.
4.
Afloje los tornillos de fijacion de la tapadera de la bomba.
5.
Retire la tapadera de la bomba (tenga cuidado) no dane el empaque
de adentro con herramienta afilada.
6.
Limpie la tapa de la bomba.
7.
Quite toda la suciedad y residuos del rodete de la bomba.
8.
Compruebe que el rodete puede girar libremente.
9.
Ensamble la bomba de hundimiento correctamente y comprube que
todo trabaje propiamente.
CUIDADOS CON BOMBA DEL AGUA
•
Nunca use la bomba sin agua en la bandeja. Llene la bandeja de agua
de manera que el agujero de absorsion quede completamente
hundido.
•
Asegurese de conectar el enchufe a un toma corriente conectado a
tierra en forma apropriada para reducir el riesgo de choque electrico.
•
Desconecte la bomba antes de manejarla o tratar de desmontarla o
dar servicio a la bomba en cualquier forma.
•
Asegurese de sostener la bomba durante la instalacion para prevenir
danos o fallas.
-16-
Publicidad
