Publicidad
STEP 4B
Each cabinet door is different,
so make sure the door
brackets line up with the thick
portion of the cabinet door
(See Figure 4B). This will ensure
that the screws will not go
completely through the door.
NOTE: Plastic spacers are
provided if the door brackets
need to be extended further
to reach the thick portion of
the door (See Figure 4C). If so,
you will need to replace the
bolts (part number 12) with the
1
/
" bolts (part number 13).
1
4
STEP 5A
Refer to Figure 5A to
determine door mounting
hole locations. Transfer these
dimensions to your door from
the bottom and mark the
hole locations. Pre-drill these
holes on the back side of your
cabinet door, making sure not
to drill through the door.
3
32
STEP 5B
ALTERNATE METHOD
Apply double stick tape to the
door brackets. Attach cabinet
door to the brackets while
trying to keep door level. Don't
worry if it is off a little. This can
all be adjusted. Double stick
tape will hold the door in place
while you screw the brackets to
cabinet door. (See Figure 5B)
NOTE: Although this method
is the quickest and easiest
method to attach the door, it
does limit adjustability since the
door will become adhered to
the brackets
INSTALLATION INSTRUCTIONS: 53WC SERIES PULLOUT WASTE CONTAINER
/
"
5
8
PART NUMBER 15
1)
Make sure that your unit is securely installed into your cabinet. Remove the cabinet door and
hinges to begin to mount your door.
1.
2)
Measure from frame to top bracket slot ________
Using the (4) provided screws and nuts, attach the L-Brackets to your slide.
Note: Depending on your particular basket design L-Bracket will mount on either inside or
Measure from frame to bottom bracket slot ________
outside of wire.
Inside wire shown
3a)
Attach the door brackets to the outside of the L-brackets using the (4) provided screws.
FIGURE 4B
FIGURE 4C
FIGURE 5A
2.
Measure Opening Height ________
Measure Door Height ________
Height Difference ________
Divide Difference by 2 ________
FIGURE 5B
3b)
Cada puerta de gabinete es
con la porción gruesa de la puert
dañen su puerta.
Chaque porte d'armoire est diffé
3.
la partie épaisse de la porte de l'
If your door is larger than cabinet
à travers et endommager votre p
opening, add the divided difference
you found in step 2 to the
measurements in step 1. If your door is
smaller, subtract the divided difference
from the measurements in step 1.
Top Measurement ________
Bottom Measurement ________
Mark screw locations
on your door and
3c)
pre-drill. Be careful
Se proveen espaciadores de
not to drill through the
dos para alcanzar la porción grues
cabinet door.
Des espaceurs en plastique sont
pour atteindre la partie épaisse d
4)
Aplique cinta de doble lado a
soportes mientras trata de manten
poco, esto puede ser ajustado. La
atornilla los soportes a la puerta d
Mettez du ruban adhésif double
supports tout en essayant de ma
tout à fait à niveau, tout cela peu
pendant que vous vissez les supp
3
Publicidad
