Publicidad
Lay the black antenna wire on the top of the receiver (J).
Insert the receiver (J) into the container on the inner side
of the mounting bar (K).
Installing the motor
With the motor assembly (B) sitting on the hook, pilot the
mounting bar (K) onto the hanger bracket (A). Insert the four
threaded rods (II) on the hanger bracket (A) into the four
screw holes on the mounting bar (K). Secure the mounting
bar (K) by tightening the flat washers and hexagon nuts (HH)
as removed earlier.
Remove the four side screws (JJ) from the sides of hanger
bracket (A).
Attaching the motor housing
Place the motor housing (C) over the motor assembly (B)
and against the ceiling, matching the holes on the motor
housing (B) with the holes on the sides of hanger bracket
(A). Secure the motor housing (C) with the four side screws
(JJ).
J
II
HH
B
1-855-HD-HAMPTON
K
A
JJ
K
B
JJ
C
Publicidad
