Troubleshooting - Packard Bell Easy Guia Del Usuario

All manuals and user guides at all-guides.com
Easy DVD Recorder User's Guide
VII. Troubleshooting
Problem
No sound
Only sound, no
picture
No response
Remote control does
not work
Cannot play disc
Solution
Connect the audio cables into the jacks securely.
Verify the connection from the DVD audio output to the TV or
receiver audio input. Make sure the correct audio input is
selected on your TV or amplifier.
Refer to your audio amplifier documentation.
The scan mode of video output is incorrectly set. Press PSCAN
on the remote control to switch to correct mode.
Connect the power plug into the wall outlet securely.
Time recording is proceeding. Press STOP to cancel time
recording.
The device might encounter a technical failure. Unplug the
power cord and wait for 30 seconds before connecting it to the
wall outlet again. If it still doesn't work, try to reset the
DVD Recorder
to factory settings.
The remote control is not pointing to the
Easy DVD Recorder
Please aim at the
Batteries are low, replace them.
The unit might encounter a technical failure. Unload batteries,
wait for 30 seconds before placing them back into the remote
control.
The disc is blank, replace it.
Incompatible disc: please check the "
guide.
The disc is loaded with label side down. Load the disc with label
side up.
The region code does not match the region setting of the
DVD Recorder.
Parental lock is on, unlock it. Default password is 3308.
Choose channel number on the TV set. Choose a correct
channel number.
The connection between the DVD recorder and TV set is loose.
Check the connection.
Easy
Easy DVD Recorder.
.
Disc specifications
" in this
Easy
37