Installation; Mounting - Resol PSW Basic Manual

2

Installation

2.1

Mounting

80
WARNING! Electric shock!
Upon opening the housing, live parts are
exposed!
Î
Always disconnect the device from
power supply before opening the
housing!
Note
The device is suited for stationary mounting only.
Pay attention to strain relief when routing the ca-
bles.
The unit must only be located in dry interior rooms. It
is not suitable for installation in hazardous locations and
should be protected against electromagnetic fields.
The device must additionally be supplied from a double
pole switch with contact gap of at least 3 mm.
Please pay attention to separate routing of sensor cables
80
and mains cables.
Î Determine the mounting site and mark the holes
through the fastening points.
Î Drill holes and insert the wall plugs.
Î
Fasten the housing.
Î
Unscrew both screws.
Î
Remove the upper part of the housing.
Î
Carry out the electrical connection.
Î
Attach the upper part to the housing and tigthen both
screws.
13