OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE
The power tool is intended for driving in and loosening
screws as well as for drilling in wood, metal and plastic.
ACTION
BEFORE OPERATION
Charging the Battery
NOTE:
1. Maximize Battery Performance
Prior to initial use, the battery must
be charged 5 hours to fully utilize the
battery capacity.
2. When the battery is full charged, the
light turns green.
ASSEMBLY AND ADJUSTMENT
Inserting and Removing the Bit
Cartridge
Assembling and Removing the Screw
Holder
Forward/reverse/lock
WARNING: Never change the
direction of rotation when the
chuck is rotating, wait until it is
stopped!
OPERATION
Selecting a Bit
Drilling a Pilot Hole
Assembling screw
Tightening and Loosening Screw
FIGURE
Operating the On/Off Switch
WARNING: Do not operate for
long periods at low speed
because excess heat will be produced
internally.
LED Light Indicator
See Fig. A
Automatic Spindle Locking
NOTE: When the slide driver is out of
power, this function enables the cus-
tomer tightening or loosening screws
manually.
See Fig. B,C
MAINTENANCE
See Fig.
Your power tool requires no additional lubrication or
D1,D2
maintenance. There is no user serviceable parts in your
power tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
See Fig.
store your power tool in a dry place. Keep the motor ven-
E1,E2,E2
tilation slots clean. Keep all working controls free of dust.
If you see some sparks flashing in the ventilation slots,
this is normal and will not damage your power tool.
See Fig. F1,F2
See Fig. G
See Fig.
H1,H2,H3
See Fig. I1,I2
See Fig. J
See Fig. J
17