Programme Operation; Running Maintenance: All Models; Cleaning The Filter; Cleaning Your Drier - Brandt ETE 762K Guía De Utilización

Programme operation

Action or condition
Light permanently lit
Start Operating (1)
Automatic programme
All fabrics - Ready to store
Programme selection Operating (1)
Selected programme
Immediate start (10 to 20
Operating (1)
minutes) Selected programme
Immediate start (after the
Operating (1)
first 10 to 20 minutes) Selected programme
Delayed start (1 to 9 Operating (1)
hours, hour by hour) Selected programme
Pause drying (during the Operating (1)
stop phase) Selected programme
Pause drying (POSISTOP Operating (1)
activated: door up) Selected programme
Continue programme Operating (1)
Selected programme Selected programme
Drying Operating (1)
Selected programme
Cooling down Operating (1)
Selected programme
Operating (1)
Untangling (24 hours
Selected programme
max.) Then drying is
complete
End of cycle (when you Operating (1)
open the door)
*nota
You have the choice of the during time : 30 or 40 mintes by
pressing "delayed start".
(1) The operating light is only present on extraction models.
(2) The tank full light is only present on condenser models.
Cooling down: this comes on during the last part of the drying cycle.
Buzzer: an audible signal during untangling, (selectable throughout the whole cycle)
Untangling: this comes on when drying has finished and avoids the items becoming
entangled.
Flashing light Display
flashing
Time of selected
programme
Approx times and
, alternately
Remaining
drying time
Delayed start
time remaining
flashing
permanently lit
Remaining
drying time
Remaining
drying time
Remaining
drying time
permanently lit
Filter, tank full (2)
or flashing depending
buzzer (if selected)
on whether the drum
is fixed or not
Filter, tank full (2)
Selected programme permanently lit
12

Running maintenance: all models

Cleaning the filter

We would remind you that the filter must be
cleaned after every cycle.
The filter is located on the left-hand side
inside the drum.
To clean it:
- Remove the filter from its holder by pulling
it from bottom to top. (Fig. 11)
- Clean the filter by removing the thin layer
of fluff covering it (Fig. 12)
The filter must never be rinsed in water.
(Fig. 13)
- Replace the filter in its holder, pushing it in
completely.
Use some of the fluff rolled into a ball to
rub the filter to unstick the fibres from it.
Every 6 months, vacuum the ventilation
grills at the front and back of the machine
to remove any dust and fluff.

Cleaning your drier

Only use a sponge or a damp cloth with soap
and water to clean the control panel, the access
to the drum and the outer casing.
In any case, do not use (Fig.14):
• Abrasive powders
• Metal pads or plastic sponges
• Alcohol-based products (alcohol, thinner,
etc.)
Fig.11
YES
OUI
Fig.12
Fig.13
NO
NON
Fig.14
13