Freezer Features - Crosley CB22G6Q Manual Del Propietário

Freezer features

Automatic ice maker
(SELECT MODELS)
Using ice maker for the first time:
Confirm ice bin is in place and ice
maker arm is down.
After freezer section reaches between
0° to 2° F (-18° to -17° C), ice maker
fills with water and begins operating.
Allow approximately 24 hours after
installation to receive first harvest of ice.
Discard ice created within first 12
hours of operation to verify system is
flushed of impurities.
Operating instructions:
Confirm ice bin is in place and ice
maker arm is down.
You will have a complete harvest of
ice approximately every 3 hours.
Stop ice production by raising ice
maker arm until click is heard.
Ice maker will remain in the off posi-
tion until arm is pushed down.
CAUTION
To avoid property damage, observe
the following:
DO NOT force ice maker arm down
or up.
DO NOT place or store anything in
ice storage bin.
9
Shelves
ICE SERVICE RACK
(SELECT MODELS)
To install rack:
Slide L-shaped groove of shelf down
over back wall screw. Push rack back
until screw is stopped in L-shaped
groove (1). Slide front portion of shelf
over front wall screw (2).
1
2
To remove rack:
Reverse above procedure.
FREEZER SHELF
To remove shelf:
Pull shelf out to full extension. Tilt up
front of shelf and pull straight out.
To reinstall shelf:
Insert shelf into refrigerator liner rails
and push to back of compartment.
Drawers
WIRE BASKET
To remove basket:
Pull basket out to full extension. Tilt up
front of basket and pull straight out.
To reinstall basket:
Insert basket into refrigerator liner rails
and push back into place.
Door storage
TILT-OUT BIN
(SELECT MODELS)
The tilt-out bin in the freezer door tilts for-
ward for easy access to stored items.
To remove door shelf:
Lift assembly from side liner tabs and
pull out.
To reinstall door shelf:
Fit ends of shelf assembly on liner
tabs and slide down.
Accessories
ICE CUBE TRAY
(SELECT MODELS)
The ice cube tray provides an area to
freeze cubes for manual dispensing of
ice.
To release ice cubes from tray, hold tray
upside down over a storage container
and twist both ends of tray until cubes
release.