Ega Master DRAINMATIC MAX 600 Manual De Instrucciones página 10

To connect the different bits (1) and the rods, use this early system:
- To attach the drill bits or rods: simply connect the two ends with the early coupling system
indicated in image (2).
- To release: introduce the tool * as shown in the image (3), will drop and leave a hollow
piston, which is where we fit the accessory you need.
*Tool included.
To remove the accessory tool * is introduced as indicated in the previous point and when
the piston is pulled down slightly from fitting out.
Proceeding as discussed above is achieved by separating the plug of the accessory.
IMPORTANT!
The maker will not take responsibility for damage or malfunction as a result of the machine
being incorrectly used or, applied for a purpose for which it was not intended.
For ordering spare parts, please refer to the Spare Parts Drawing and note the needed number.
According to Waste Electrical and Electronic Equipment directive (WEEE), these ones must
be collected and arranged separately. If you have to throw them out, please, do not use the usual
rubbish. Please, contact your distributor for free recycling.
The maker guarantees to the machine owner 12 months against any manifacture defect.
This guaranteee do not cover the parts wich are consumables.
Note: to apply the guarantee its necesary to send the "GUARANTEE CERTIFICATE" duly filled
within one week after purchased the machine to the maker.
10
INSTRUCTIONS FOR CHANGING THE ACCESORIES
GUARANTEE
NOTES