Maintenance And Storage - GRE RBR60 Manual De Instrucciones

3
When the robot has no power, it will automatically stop at the edge of the pool.(may also get stuck in the middle of the
pool by obstacles)
Note:
1. It is recommended to turn off the filtration system as the water circulation in the pool may affect the robot's motion
mode.
2. Any obstacle in the swimming pool will affect the robot's crawling and cleaning track, such as ladder;
3. If you are using a brine tank, make sure that all the salt is dissolved before putting the robot into the water.
For correct operation of the device the floor must be completely flat and there must not be any wrinkles in the liner (fabric
containing the water), in the case that the pool is made of this material
GARBAGE DISPOSAL
1.
5.

MAINTENANCE AND STORAGE

1. The battery discharges itself during storage. Make sure the robot is fully charged before storage.
2. When not in use, you must recharge the battery at least every three months.
• Unplug the external adapter from the socket and then the charging cable from the external adapter and the robot.
• Remove the attachment from the robot. If necessary, rinse the robot and accessories with clean water. Do not use
detergent.
• Before storage, make sure the robot is drained.
• Use a wet cloth to clean and dry the robot and its accessories.
• Store in a well ventilated place away from sunlight, heat, fire sources, pool chemicals and children.
• The storage environment temperature should be 10 ºC – 25 ºC (50 ºC– 77 ºC).
Note: higher storage temperatures may shorten battery life.
2.
3.
Adjust the length of the
rope to ensure that the
length of the rope is at
the same height as the
water level, and the ex-
tra length of the rope is
tied or cut short.
4.