Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION REQUIREMENTS
INSTALLATION HARDWARE
Your air conditioner will install into standard double
hung windows with actual clear opening widths of
22 to 36 inches (558mm to 914mm) (FIG. 1).
Lower sash must open sufficiently to allow a clear
vertical opening of 14 inches (356mm). Side louvers
and the rear of the air conditioner must have clear
air space to allow enough airflow through the
condenser for heat removal. The rear of the unit
must be outdoors, not inside a building or garage.
•_22"
to 36" --
14"rain
Intedor wall
Sash
Winddow
"-_,_-
Offset
• -- Sill
-- Exterior
"" .... "
FIG. 1
ELECTRICAL
SERVICE
Check your available electrical service. The power
supply available must be the same as that shown on
the unit nameplate (found on left side of cabinet).
All models are equipped with a 3-prong service plug to
provide proper service and safe positive grounding. Do
not change plug in any way. Do not use an adapter
plug. If your present wall outlet does not match your
plug, call a qualified electrician to make the necessary
corrections. SAVE CARTON and this OWNER'S
MANUAL for future reference. The carton is the best
way to store unit during winter or when not in use.
To avoid risk of personal injury, property damage, or
product damagedue to the weightof this device and
sharp edges that may be exposed:
• Air conditionerscovered in this manualpose an
excessiveweight hazard. Two or more peopleare
needed to move and install the unit.
To prevent injury or strain, use proper tiffing and
carrying techniqueswhen moving unit.
• Carefully inspect location whereair conditioner will
be installed. Be sure it will support the weight of
the unit over an extended period of time.
• Handle air conditioner with care. Wear protective
gloves wheneverlifting or carrying the unit. AVOID
the sharp metal fins of front and rear coils.
• Make sure air conditioner does not fall dudng
installation.
ITEM
NAME OF PARTS
Q'TY
A
SHORT SCREW
11
B
WOOD SCREW
5
C
L BRACKET
3
D
FOAM STRIP
1
E
FOAM SEAL
1
F
SIDE CURTAIN
2
G
DRAIN PIPE
1
H
SUPPORT BRACKET
1
REQUIRED T(3OLS:
• Tight Fitting gloves
• Standard screwdriver
• Phillips screwdriver
• Pliers
• Sharp knife
• 3/8-inch open end
wrench or adjustable
wrench
• 1/4-inch hex socket
and ratchet
• Tape measure
• Electric ddll
• 1/4-inch drill bit
-5-
Publicidad
Capítulos
Tabla de contenido
