Bond HYFP50095-45 Manual Del Propietário página 7

** Connect the Pressure-Regulating Valve to the gas tank. See
Figure F.
1) Turn the cylinder valve clockwise to close the gas supply on
the gas tank.
2) Screw Regulator Coupling clockwise by hand only. Make sure
it is fastened.
See WARNING and Figures :
WARNING
This screen must be clear and free of obstructions
at all times to insure proper operation.
WARNING
The burner of the fire table must be covered by
lava rock completely. Otherwise the flame may be
extinguished occasionally. See the Figure
CORRECT and INCORRECT for reference.
Perform leak test in a well ventilated area outside and where no source of spark can occur.
Remove battery from igniter. Open tank valve fully (counter-clockwise). Turn the on/off valve at the unit to the 'off' position to
pressurize the hose assembly. Use a soapy water solution to check all the connections leaks before attempting to light the appliance. If
a leak is found, turn the tank valve off and do not use the appliance until repairs can be made.
TIPS:
Before Beginning
TO LIGHT
Before each use, inspect all hose. Replace hose if there are any signs of cutting, wear or abrasion.
(1) Turn the cylinder valve on the gas tank counter-clockwise to open the gas supply.
(2) Light the fire table as below steps:
A. Press and hold the Electric Ignitor. Meanwhile, push and turn the Control Knob counter-clockwise to the "LOW" position.
Keep pushing the Control Knob to light the burner .
B. After ignition, release the Electric Ignitor. Continue to push and hold the Control Knob for 45 seconds.
C. If ignition does NOT immediately take place in seconds, push and turn the Control Knob clockwise to "OFF". Wait 5
minutes, then repeat the lighting procedure as above.
● Read the instructions thoroughly.
●Check and make sure that all parts are present.
●For future reference, save this instruction sheet.
7
CORRECT
OFF
IGNITER-PUSH
INCORRECT
HIGH