Publicidad
Step 4
NOTE: The SKIRT (I) and DRAWER FRONT MOLDINGS (J)
å
will have a white and brown surface. You can choose which
surface you want to face to the front of your unit. During
assembly, be sure the surfaces are all the same color.
Insert two METAL PINS (1R) into one of the BOTTOMS (D).
å
Insert the METAL PINS (1R) in the BOTTOM (D) into the
å
holes in the SKIRT (I).
Then, insert a METAL PIN (1R) into the short edge of the
å
SKIRT (I).
Fasten the BOTTOM (D) to the LEFT END (B). Use two
å
BLACK 1-7/8" FLAT HEAD SCREWS (2S).
NOTE: Be sure the METAL PIN in the SKIRT inserts into
å
the hole in the LEFT END.
BLACK 1-7/8" FLAT HEAD SCREW
(2 used in this step)
Page 8
Unfi nished edge
2S
D
Finished edge
B
I
D
417070
I
1R
1R
www.sauder.com/services
Publicidad
