Fitting Instructions - Suzuki 990D0-05H00-ALM Manual Del Usuario

PRIOR TO FITTING
1. Check that all the parts shown are included in the Kit.
2. Check the condition of each individual part.
3. Park the vehicle in a stable manner.
4. Take the key out of the ignition.
5. Protect all parts removed from the vehicle.
6. Be careful not to damage any vehicle parts during fitting.
The condition to assemble parts is technical experience.
If you not sure if you do a special work step, you should ask your next SUZUKI dealer.
STEP-BY-STEP FITTING GUIDE
The Alarm wiring in this Kit is adaptable to the Burgman range.
The models are listed in the manual in the "Applications" section.
The wiring must be adapted once you have selected the vehicle in which this Alarm Kit
is to be installed. The assembly instructions are shown in photo A.
STEP-BY-STEP FITTING GUIDE - BURGMAN 650
The vehicle's original electrical system is pre-engineered for connecting the alarm system.
The two connectors (one-pole connector and four-pole connector, closed with counterpart)
Photo A: Clean the base of the alarm control unit and apply the larger piece of double-sided adhesive
tape supplied in the kit (1).
Connect the connector of the alarm wiring to the control unit, fit the rubber cap into the relative housing
and fix it in place with the plastic clamp (2). Turn the antenna and fix it into the slot in the control unit
(3) with the clamp.
Definition of the connectors; (4) Pre-engineering for the Alarm, (5) Turn indicators, (6) LED.
Adapt the alarm wiring to suit the dimensions shown in the picture (A).
Take particular care to ensure that the branch of wiring with connector (4) is 150 mm in length.
The branch with connector (6) must be joined to the branch with connector (5), in compliance with the
60 mm dimension given.
Photo 1: Remove the portion of fairing from above the headlight (A) by unscrewing the two screws near
the rear view mirrors and extracting the central pin from between the two headlights. Disassemble the
main fairing by unscrewing the screws from around the perimeter of the vehicle. Lift up the two foot mats
and remove the screws and plastic clips until you reach halfway along the central tunnel. There are other
screws and clips to remove in the internal front area alongside the radiator (B).
Photo 2: Position the Alarm control unit assembly on the left-hand side, under the storage space (C).
Fix the Alarm control unit in place with the double-sided adhesive tape. Remove the protective film and
set the base of the control unit in position, press down for at least 15/20 seconds (D) then route the
wiring towards the front part of the vehicle (E).
Photo 3: Wire up the two alarm connectors (F) then proceed by routing the wiring (G), which should be
fixed in place with plastic clamps (H) and (I).
Photo 4: Remove the vehicle's engine control unit from under the main instrument panel (L). Find the
13-pin connector of the commutator on the left-hand side, disconnect it, and insert the connectors of
the alarm wiring.
Photo 5: Fix the LED above the handlebar, in the center of the instrument panel using two-sided adhesive
tape (M) and press down for at least 15/20 sec. Make the electrical connections with the two-way
connector. Fasten the Led wire as shown in photo 5 ref. (N).
4

Fitting Instructions

CAUTION
CAUTION
NOTE
are in the front part, above the radiator.
State of the art. 10/2006
SUZUKI GENUINE ACCESSORIES
EN