Liemke MERLIN–35 Manual De Instrucciones página 26

> Use the /
• In the X-axis, briefly pressing the
the right, briefly pressing the
Y-axis, pressing the
pressing the
• With one press of the button, the point of impact at a distance
of 100 m shifts by 1.66 MOA, i.e. 4.8 cm; this applies to both axes.
Examples:
If the point of impact (at 100 m) is 10 cm to the left of the target
point, correct the value on the X-axis by pressing the
twice.
If the point of impact (at 100 m) is 5 cm too high, correct the
value on the Y-axis by pressing the
> Save the settings by pressing the button to the right or left.
The Exit menu appears on the display.
> Confirm leaving the menu by pressing the
NOTE:
> Before each use as an attachment, check that the correct Unit
mode is selected.
> Make sure that the mounting of your optics is sufficiently high for
the attachment mode to ensure a minimum distance of approx.
10 mm between the lower edge of the clamping adapter and
the barrel of the rifle.
> Make sure that the rear sight of an open sight also maintains
the appropriate distance to the clamping adapter or Merlin-35
(2020).
If this distance is not maintained, this can lead to contact and
impacts when firing, which in the long run can cause damage to
the thermal sight, scope and mount.
> Make sure that the clamping of the attachment optics sits tightly
on the tube of the scope, i.e. the optics cannot still be pulled off
at the front by hand. To increase the clamping tension, the lever
force can be adjusted with the screw on the clamping adapter.
• The attachment optics must be adjusted to the respective
intended day optics according to the instructions.
• A test shot is essential after calibration to ensure the same point
of impact of the day optics.
> When actively using the optics (e.g. stalking), make sure that the
clamping position of the attachment optics does not change
due to impacts, etc.
buttons to change the values (-15 to +15 clicks).
button briefly moves the screen upwards,
button moves it downwards.
button moves the screen to
button moves it to the left. In the
button.
button
/ buttons.