Assembly And Adjustments - Truper Expert MADE-30NX Manual De Instrucciones

Assembly and adjustments

Assembly and adjustments
Accessory mounting
CAUTION To prevent accidents, confirm that the
switch is off and disconnect the plug from the power
supply.
WARNING
Wear gloves whenever you change
accessories. They can become extremely hot during the
operation.
• Clean the accessories shanks and apply grease before
mounting in the tool chuck (A).
• The attachments are secured in the tool chuck by the
retaining lever (B). The position of the lever depends on
the type of shank of the fixture being used, usually slotted
or shouldered.
SLOTTED ACCESSORIES (C)
• Move the lever towards the tip of the drill bit without
reaching the tool axis (D).
• Insert the accessory into the drill chuck.
• Return the lever to its original position to lock the
attachment (E).
• Pull the bit to confirm that it is fully secured.
• To remove the accessory, move the lever to the tip of
the drill chuck and remove the accessory.
ACCESORIES WITH SHOULDER (F)
• Move the lever towards the tip of the drill bit until
reaching the tool axis (G).
• Insert the accessory into the drill chuck.
• Return the lever toward the accesory to lock it (H).
• Make sure the shoulder is inside the retaining lever.
• Pull the bit to confirm that it is fully secured.
• To remove the accessory, pull the lever and remove the
accessory.
A
C
F
G
H
B
D
E
ENGLISH
7