Manuales relacionados para Truper Expert TAMA-2N
Resumen de contenidos para Truper Expert TAMA-2N
- Página 1 Instructivo de Magnetic 2” Drill Cutting Depth Applies for: Code Model 100989 TAMA-2N TAMA-2N Read this manual thoroughly CAUTION before using the tool.
-
Página 2: Tabla De Contenido
Contents CAUTION Technical data Power Requirements To gain the best performance of the tool, prolong the duty life, General power tool safety warnings make the Warranty valid if necessary, and to avoid hazards Safety warnings for the of fatal injuries please read and use of magnetic drills understand this Manual before using the tool. -
Página 3: Technical Data
Technical Data TAMA-2N Code 100989 Description Magnetic drill Weldon socket 3/4” Voltage 127 V~ Frequency 60 Hz Current 10 A Power 1 200 W Maximum cutting depth 2” Maximum cutting capacity 1 3/8” with annular bits Minimum plate thickness 3/8” Speed 550 RPM Work cycle... -
Página 4: General Power Tool Safety Warnings
General power tool safety warnings WARNING! Read carefully all safety warnings and instructions listed below. Failure to comply with any of these warnings may result in electric shock, fire and / or severe damage. Save all warnings and instructions for future references. -
Página 5: Safety Warnings For The Use Of Magnetic Drills
Safety warnings for the use of magnetic drills Choose the appropriate bit or attachment While operating the drill CAUTION • The tool is designed to work with CAUTION • Hold the tool by its handle and by Weldon stilts cutters or accessories. Choose the right one the auxiliary handle. -
Página 6: Parts
Parts Protection Allen guard Chuck ON / OFF switch Annular Chuck Drill adapter Safety Sliding belt plate 5/8” chuck Weldon socket Magnetic base Coolant bottle Power cord Carbon brush cover Handle Feed handle Flow coolant valve ON / OFF switch for the magnetic base Fuse... -
Página 7: Mounting
Mounting Feed wheel • Screw the three handles (A) to the feed wheel (B). CAUTION Always use the tool with the feed wheel properly mounted. Safety guard • Set the safety guard (C) using the included screws. Cooling system WARNING Never operate the magnetic drill without using coolant, or when drilling horizontally, a suitable cutting paste. -
Página 8: Safety Belt
Mounting Bits and accessories CAUTION The annular cutters are very sharp. It is recommended that the operator wears protection when handling it for installation or removal. • Check that the cutter is sharp and does not have any damage. CAUTION No cutters should be used damaged or dull. -
Página 9: Start Up
Start up CAUTION The drill can only be used in uncoated tempered steel. Make sure the surface is free of paint and loose rust before attempting to drill. Material that has been cut with flame CAUTION can be converted into heat-treated material and therefore is difficult to puncture. -
Página 10: Maintenance
Maintenance Cleaning and care • Clean the machine with a soft cloth, moistened with soap and water, preferably after each use. • Always keep the vents clean and unobstructed to ensure proper motor cooling. • Regularly inspect all mounting screws and make sure they are properly tightened. -
Página 11: Authorized Service Centers
In the event of any problem contacting a Authorized Service Center, please see our webpage www.truper.com to get an updated list, or call our toll-free numbers 800 690-6990 or 800 0187-8737 to get information about the nearest Service Center. DE TODO PARA LA CONSTRUCCIÓN FIX FERRETERÍAS... -
Página 12: Warranty Policy
. Transportation costs resulting from compliance of this warranty will be covered by For questions or comments, call 800-690-6990. Made in China. Imported by Truper S.A. de C.V. Parque Industrial 1, Jilotepec, Edo. de Méx. C.P. 54240 Stamp of the business.