Solving Problems - Barbecook Brahma 2.0 ceram Manual Del Usuario

SOLVING PROBLEMS

Problem
Impossible to light burner (with igniter
or match)
Not enough heat
Yellow flames
Flames jumping out of the burner box
Excessive heat and flare-ups
Flames behind control panel
Regulator humming
Incomplete flame
TROUBLESHOOTING GUIDE FOR ELECTRIC IGNITION
Problem
No sparks when pressing the ignition;
no sound
No sparks when pressing the ignition;
sound is present
Sparks are present but not with all elec-
trodes and/or not powerful enough
AROMAZ ® SYSTEM
Under the grid of the Brahma are two saucers that you can
fill with your favourite barbecue seasoning (wine, beer, port,
herbs or smoke chips with water, etc.).
Probable cause
• Blocked venturi tubes
• Gas cylinder valve is not open
• Venturi tubes not positioned over exhaust valves
• Blocked burner openings
• Cylinder is empty or almost empty
• Regulator not fitted correctly on cylinder
• Venturi tubes are partly blocked
• Salt on burner
• The product is connected to Buthane.
• Windy weather
• Cylinder almost empty
• The bottom of the burner bowl is dirty.
• Too fatty food
• Blocked fat drain hole
• Cooking system not positioned correclty
• Blocked venturi tubes
• Temporary situation caused by high outside temperature or
full cylinder
• Blocked, pierced or rusted burner
Probable cause
• Battery not installed correctly
• Empty or missing battery
• Ignition button not installed correctly
• Defective spark generator
• Faulty ground
• Burner and electrode are positioned too far apart
• Faulty ground
• Spark flashover away from burner(s)
• Low battery
• Electrodes are wet
• Electrodes cracked or brokenn "sparks are present"
Solution
• Clean venturi tubes
• Open gas cylinder valve
• Reinstall venturi tubes
• Clean openings or fit new burner
• New cylinder
• Tighten up connector of regulator
• Disconnect hose
• Clean venturi tubes
• Clean burner
• Connect the product to Propane with the right connector.
• Move barbecue with rear side pointing towards the wind
• New cylinder or fill up
• Clean the fire bowl of the barbecue.
• Trim excess fat or reduce heat
• Clean bottom of burner box and burner
• Position cooking system correctly
• Shut off gas immediately, allow barbecue to cool down and
clean venturi tubes
• This is not a defect or a hazard
• Clean / replace burner
Solution
• Install battery (ensure that "+" and "-" are oriented cor-
rectly, with "+" at the top and "-" at the bottom)
• Replace with new AA battery
• Screw off button and reinstall
• Replace spark generator
• Remove and reconnect all connections with spark generator
and electrodes
• Bring the electrode closer to the burner by bending it slightly
• Remove and reconnect all connections to the spark genera-
tor and the electrodes
• If sparks are present that do not originate from the
burner(s), the wiring may be damaged. Replace the wiring.
• Replace with new AA battery
• Use paper tissues to remove the dirt
• Replace cracked or defective electrodes
The Aromaz ® system makes for the juiciest and most flavourful
dishes ever prepared on a gas barbecue.
www.barbecook.com 45