Basic Setup - NGS Technology Helium Manual Del Usuario

Cleaning
•
Use a soft cloth with a little neutral detergent to wipe the cabinet, panel and controls. Never use
abrasive paper, polishing powder or any solvent such as alcohol or gasoline.

Basic setup

1. Extend the FM antenna
Pull out the telescopic antenna. Incline and turn the antenna. Reduce its lenghth if the signal is
too strong (very close to a transmitter).
2. Insert batteries into the Remote Control
•
Insert two AAA batteries into the remote control while observing the correct (+) and (-) polarities as
shown
• Remember to replace the battery compartment door after inserting the batteries.
• The remote control range is approximately 5 metres. Keep within about 30 degrees of the remote
sensor.
3. Connect the power
This system is designed to operate on 230V 50Hz AC house current. Connecting this unit to any
other power supply could result in damage to the unit which is not covered by your warranty.
4