Vollrath CADJ-1 Instrucciones De Instalación página 2

3. Rotate the adjustment ring to reveal the mounting holes.
Mounting
hole
Mounting hole
4. Place the tube into the cut mounting hole. Mark the mounting hole
locations.
5. Remove the dispenser from the mounting hole.
6. Pre-drill pilot the pilot holes. Vollrath suggests a ¹⁄₈" (0.125)
diameter pilot hole diameter of ¹⁄₈" (0.125).
7. Insert the dispenser into the cutout hole and align the mounting
holes to the pre-drilled holes.
8. Insert the included screws into the mounting holes. Tighten snuggly.
2
ADJUST DIAMETER TO FIT CUPS
1. Loosen, but do not remove adjusting ring screws.
Mounting
Adjusting
hole
Ring Screw
2. Rotate the adjusting ring to widen the opening.
3. Insert a short stack of cups into the dispenser.
4. Rotate the adjusting ring until the cups are held in place.
Spring Loaded In-Counter Cup Dispenser Operator's Manual
Adjusting
Ring Screw
Adjusting Ring Screw