Electrical Connection; Putting Into Operation; Controls And Operation - ROTOR RBB2 Manual De Instrucciones

© Rotor Lips AG

5. ELECTRICAL CONNECTION

The power supply voltage must correspond to the values on the
rating plate on the appliance (the voltage rating is given in volts [V])
The appliance should only be connected to a single phase grounded
alternating current. Make sure that the original mains cable and
the wall outlet correspond.
For safety reasons the outlet must have a faulty-energy-protection switch (FI).
Appliances with a 230 V designation can also be used with a 220 V mains supply.
If at all possible, avoid using an extension cord. If it is unavoidable, only proper, approved
extension cords should be used.
Do not subject the mains cable to strong tension or pressure.
To replace the cable, see chapter "Repairs".

6. PUTTING INTO OPERATION

Before using the appliance for the first time it must be thoroughly cleaned.
Follow the instructions in the chapter "Cleaning".
Place the Rotor Bar Blender on a firm, flat base and plug it into a nearby, appropriate
electrical outlet.
Before connecting the appliance to the mains electricity supply it must be
switched off at the main switch (Position: "OFF") and stood in a stable position.
Note
The windings of the Rotor commutator motors are covered with high-quality insulating
lacquer. For this reason, the motor may, at first, exude an odour when it heats up.
This is normal and does not damage the motor; it disappears after the motor has been
used several times.

7. CONTROLS AND OPERATION

Container assembly
- Insert the cutter head together with the gasket into the threaded ring.
- Screw the bowl turning counter clockwise into the threaded ring.
- Always ensure that it is inserted straight.
14
Instruction Manual
Rotor Bar Blender
The cutter blades are sharp and may cause
bad injuries.
CH-3661 Uetendorf