EXFO EPM-50 Guia Del Usuario página 15

5. Activate the source at the desired wavelength.
6. Match the source and power meter wavelengths using
Modulation detected
Actual power
or loss
of fiber under test
When the unit detects a modulated signal, it displays the modulation value and
average measured power or loss (see left illustration above). You may notice a
slightly unstable last digit.
7. If necessary, change the displayed units by pressing
8. Repeat the procedure for other wavelengths.
EPM-50/ELS-50
When power or loss is outside power limits
(see Technical Specifications on page 27)
.
.
11