How To Operate; Helpful Tips - Nostalgia Products CLSC1AQ Instrucciones Y Recetas

HOW TO OPERATE

• Place the CLASSIC RETRO SINGLE SNOW CONE MAKER on a stable,
waterproof surface near an electrical outlet before starting.
• Always make sure that the cord is away from a water source.
• Remove the Snow Cone Holder from the base of the unit and
reattach the Snow Cone Holder so that it faces upward.
• Before plugging in the unit, add approximately 4-5 medium size ice cubes to the Ice Hopper
by removing the Lid. In order to do so, turn the Lid clockwise, lift and remove.
CAUTION: Blade is VERY sharp. NEVER put fingers or utensils into feed or discharge areas.
• Plug in the unit.
• Place a cone in the Snow Cone Holder.
• When you are ready to make a snow cone, place the Lid back on the unit and turn Lid
counter-clockwise to lock. Light should be GREEN on the power gauge, indicating it's ready.
• Once lid is locked, pull the ON/OFF lever forward, turning the unit on. The
light should be RED on the power gauge, indicating the unit is running.
• The Ice Hopper will immediately begin shaving the ice. Rotate
cone with your hand as needed to collect ice.
• To stop the Ice Hopper from shaving ice, turn the Lid clockwise
or push the ON/OFF lever back, turning the unit off.
• Repeat the process until you have shaved the amount of ice desired.
• Unplug unit from outlet when finished (you can tuck the cord away in
the cord storage, which is located in the bottom of the unit).
• Total operation time is approximately 5 minutes..
By following these simple instructions, your CLASSIC RETRO SINGLE SNOW
CONE MAKER will be fun for friends, family and kids of all ages!

HELPFUL TIPS

ICE CUBES
Ice cubes should sit a short while before putting them in the shaving unit.
If ice has a frosty appearance, it is too hard to shave. Let ice sit until it is
translucent and wet to the touch. Then it is ready to put in the Ice Hopper.
SHAVED ICE
While ice is shaving, it will empty from Spout and may get on surface and floor around the
CLASSIC RETRO SINGLE SNOW CONE MAKER. This is normal. In order to prevent messes:
• Place unit on a waterproof surface while in use.
• Rotate cone in holder as needed in order to fill cone evenly.
• After you are finished making snow cones, make sure Ice Hopper
is empty so that ice does not melt onto surface.
SHAKING
If the unit begins to shake, make sure that the suction cups on the
bottom of the unit are firmly pressed into table or countertop.
6