Skil 2354 Instrucciones De Funcionamiento Y Seguridad página 10

SM 1619X05087 12-09:SM 1619X05087 12-09 1/4/10 9:18 AM Page 18
green indicator light depicting a forward arrow
will light up.
For reverse rotation move the lever to the far
right and the green indicator light depicting a
reverse arrow will light up.
To stop in either direction just release the
trigger. To activate trigger lock move lever to
the center off position (Fig. 1).
UTOLOCK™
Your tool is equipped with an automatic locking
system. This feature will lock the bit holder in
one position when the trigger switch is
released. This will allow you to tighten or loosen
a nut or screw by rotating the tool by hand with
the switch off. This is convenient when higher
turning torque is needed.
SITE-LIGHT™
Your tool is also equipped with a light that turns
on automatically when the switch is
activated for better visibility during operation
(Fig. 1). The Site-Light™ is maintenance free
and was designed to last the life of your tool.
CH RGING THE TOOL
For Model # F012235400: Plug charger into
your standard power outlet, then insert charger
plug into tool (Fig. 2).
The green charging indicator light on the tool
will turn "ON". This indicates that the battery is
receiving a fast charge. Fast-charging will
automatically stop when the battery is fully
charged.
18
When the indicator light turns "OFF" fast
charging is complete.
If the green charging indicator light turns red
during use, this indicates the battery needs to
be charged.
fter normal usage, the battery requires
approximately 3 to 5 hours charging time to
reach full capacity. The tool may be used even
though the light may still be on. The light may
require more than 3 hours to turn off depending
on temperature.
The purpose of the light is to indicate that the
battery is fast-charging. It does not indicate the
exact point of full charge. The light will turn off
in less than 3 hours if the battery was not
completely discharged.
When the battery is fully charged, unplug the
charger (unless you're charging another tool).
INSERTING BITS
Your tool is equipped with an magnetic bit
holder. Simply push the bit into the bit holder as
far as it will go (Fig. 3).
F STENING WITH SCREWS
The procedure shown in figure. 4 will enable
you to fasten materials together with your
Cordless Screwdriver without stripping,
splitting, or separating the material.
First, clamp the pieces together and drill the first
hole 2/3 the diameter of the screw. If the
19