Publicidad
Idiomas disponibles
Idiomas disponibles
A
F
x3
B
x3
3) Spread a thin film of glue in the dowel holes in the Right Leg Assembly (1c). Wipe off any
excess glue with a damp rag. Secure the Right Leg Assembly to the Back, Seat and Apron
using 6x70mm Barrel Bolts (A) and Barrel Nuts (B). The ends of the Barrel Nuts are notched
to allow a slotted screwdriver to be used to rotate the nut so that the threaded holes line up
with the bolt.
D
x4
E
x2
F
x1
4) Secure outer seat braces to Left and Right Leg Assemblies (1c & 2c) using 6x35mm
Hex Screws (D). To attach the Seat Assembly (5c) to the Front Apron (4c), insert a 4x35mm
Phillips Head Screw (E) through the pilot hole in the center brace, making sure it is fully
seated into the Front Apron. To attach the Seat Assembly (5c) to the Back Assembly (3c),
insert a 4x35mm Phillips Head Screw (E) into the remaining hole in the center brace of the
Seat Assembly (5c), making sure it is fully seated into the Back Assembly.
x1
D
4
c
D
D
D
FIG. 4
FIG. 3
D
992KFSIc – Page 4 – 10/08
Publicidad
