Setting The Unit; Main Function - Mark MULTIPAR 162/3 Instrucciones De Usuario

EN

4. Setting the unit

4.1Rear Panel
1 . DMX input: For DMX512 link, use 3/5-pin XLR plug cable to input DMX signal.
2. Display: To show the various menus and the selected functio
3.Menu
4.Up
5.Down
6.Enter
7. Mains input：Connect to supply mains power.
8. DMX output：For DMX512 link, use 3/5-pin XLR plug cable to link the next unit.

4.2 Main Function

To select any functions, press MENU button until the required one is shown on the display.
Select the function by ENTER button and the display will blink. Use DOWN and UP button to
change the mode. Once the required mode has been selected, press ENTER button to
setup . Back to the functions without any change press MENU button. The main functions
are shown below:
MULTIPAR 162/3
To select the program functions
To go forward in the selected functions
To go backword in the selected functions
To confirm the selected funtions
User Manual/Manual de uso P 3