IMPORTANT–Please Read and Follow!
• Before beginning, please read these instructions completely and carefully.
• Be sure to DISCONNECT THE PLUG of the microwave oven from the electrical outlet before installing the built-in trim kit.
Remove the turntable from the oven cavity.
• Because the kit includes metal parts, caution should be used in handling and installation to avoid the possibility of injury.
• Do not remove permanently affixed labels, warnings, or plates from the product. This may void the warranty.
• Please observe all local and national codes and ordinances.
• The installer should leave these instructions with the consumer who should retain for local inspector's use and for
future reference.
• This built-in trim kit is designed for use ONLy wITH COMBI STEAM/CONVECT™ OVEN.
• your oven can be built into a cabinet or wall or above any electric wall oven, gas wall oven or warming drawer.
• NOTE: The bottom of the cut-out opening for built-in use must be 36 inches (915 mm) or higher from the floor.
• The electrical requirements for this oven are 120 volts, 15 amps. The oven has a 5-15 plug and requires a 5-15 receptacle.
• PLEASE READ THESE INSTRUCTIONS THOROUGHLy BEFORE BEGINNING INSTALLATION!
Cabinet or wall opening
Built-in kit frame assembly
Combi Steam/Convect™ Oven
E
HEIGHT
19" - 19 1/8"
(482 mm - 486 mm)
22 1/8"
(562.1 mm)
17 1/4"
(438 mm)
1
1
wIDTH
28"
23 1/4" minimum
(712 mm)
(509.5 mm minimum)
29 1/2"
(749.3 mm)
21 3/4"
(553 mm)
DEPTH
18 3/8"
(468 mm)