PREPARING ICE CREAM VIA THE ADJUSTABLE ICE CREAM CONSISTENCY (CREAM
CONTROL)
Press
, subsequently you can adjust the desired firmness of the ice cream mass (3 level)
●
using the "+" and "-" buttons.
IMPORTANT!
If you have pressed
then press the
Press the
button.
●
Starting from 00:00, the running time is shown until the set hardness level has been achieved.
●
During the preparation process, you can refill the various ingredients through the filling
●
hole in the lid.
If the desired hardness level has been achieved, the unit will stop and three beeps can be
●
heard.
Switch off the unit or let the ice cream cool further on (see automatic cooling mode).
●
Remove the lid and the container.
●
If the container is frozen up, wait a short moment and try it again.
●
Refill the ice cream. Refill the ice cream. For removal, do not use any sharp or pointed ob-
●
jects.
AUTOMATIC COOLING MODE
If the ice cream is not removed after production, the unit will keep it cool for another 120 min-
utes. Subsequently, the unit will switch into standby mode "- -".
If you want to cool the ice cream further on, switch on the unit once again and go into the cool-
ing mode (see cooling mode).
YOGHURT MODE
IMPORTANT!
IIn contrast to the preparation of ice cream, the filled mass (max. 2L) is heated to an optimum
temperature for yoghurt preparation and then kept as constant as possible.
Switch the unit on
●
Only use the whisk if you want to stir other ingredients into the yoghurt after preparation.
●
Otherwise, you can leave out the whisk when preparing yoghurt.
Select the yoghurt mode by pressing the
●
The factory setting is 10 hours.
●
Via the "+" and "-" buttons, you can set the time in hourly steps. Maximum 24 hours.
●
Press the
button.
●
The stirring arm does not rotate, because otherwise the yoghurt production would be hin-
●
dered.
Switch off the appliance after the time has elapsed or, if the whisk was used beforehand,
●
24
by mistake and want to start the ice cream preparation via the timer,
button again. The time 60:00 is shown. Now you can set the timer.
.
button.